How To Replace The 2009 MacBook Pro LCD Assembly?

2009 MacBook Pro LCD assembly replacement
ATTENTION

All responsibilities are over you. If you make a mistake while you fixing, your device can be break down or maybe you can't use it anymore. Be careful when you trying to fix devices.

120 Min

Fixing Time

Medium

Fixing Level

SHARE
Share on facebook
Share on twitter
Share on linkedin
Share on reddit
Share on whatsapp
Share on email

T6 Torx Screwdriver, Spudger, Phillips 00 Screwdriver

1. Lower Case

Third-offense shutting down and flipping over the MacBook let’s remove the 7 short so sexy starting a clockwise Direction. What Now reboot the 3 alarm to 6 you can now look up why did water cover and move it out of the way disconnect the battery.

 

2. Disconnect The Lvds Cable

 LCD assembly removal Begin by disconnecting the lvds cable top right.

3.Remove  The LVDS Cable Bracket

 

4. Disconnect The Speaker And Wifi Cables

 

 Now disconnect speaker and the Wi-Fi cable remove the  than being held under the bed what is the speaker out of the way remove the Wi-Fi cable bracket is being held in the to protect separate the Wi-Fi cable from the speaker you can take the back roads open it up and let LCD hang over the table ledge.

5. REMOVE LCD HINGE SCREWS ON THE RIGHT

Remove the 3D set screws that are holding down the West End now remove the 3D Shape screws that hold it down the right thing you can now with us the LCD.

 

6.

 

This will send her the LCD now you can install the doors  look up the MacBook and close it l’etage the Wi-Fi cable bracket with to Phillips head screws make sure that the Wi-Fi cables underneath we entered the Wi-Fi cable into the speaker in position it we attach the speaker bluetooth on set screws one of each side.

7. Lift The LCD OUT

 We can make the lvds cable in the top right make sure to close the lvbs latch now you can please bag to lvds Cable bracket right over the table and reattaches with to Phillips head screws.

 

8. LCD  ASSEMBLY REINSTALLATION

 we can make the battery you can now please the logic board cover back on reattach to  Phillips head screws the top right of the MacBook first now we attach the seven short though it says who starred in the top left and going on around clockwise make sure to perform an MD reset after every LCD assembly installation.

 

 

 

 

 

5 1 vote
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments
0
Would love your thoughts, please comment.x
()
x

Login

You can acces your account, your notifications and your personal informations via your account.